Estate Swing User Manual download pdf (Page 3)

Installation of Components

Speaker/Microphone box:

• Take the screw out of the bottom of the box.

• The face of the speaker/mic box lifts straight off, it does not slide down.

• One the face is off you will see two screws holding the mid plate to the rear housing. Remove those

screws.

• There are 4 mounting holes in the rear housing, use flat head screws (not provided) to mount the rear

housing to a pillar, post or fence (not provided).

It is suggested to put a dab of silicone over and around the heads of the screws to keep insects and

moisture out.

• Run the 4 colored wires through to a junction box (not provided) and splice or use wire nuts to

lengthen the wire to reach your intercom control box (wire is not provided—use up to 22 gauge wire

up to 200’)

Reassemble the mid plate and the face plate.

Intercom Control Box:

• Inside the box you will find a wire with a coaxial connector and a red rubber cap.

Remove the rubber cap, nut and washer. [A]

Feed this through the hole on the lower right side of the box.

Put the nut and washer on the threads until it is secure against the side of the box.

Screw the antenna on the threads; there will be some visible thread on the coaxial connector even af-

ter the antenna is secured.

• You were provided two water tight wire connectors. Remove the back nut on the connectors and feed

through the two large holes on the bottom of the board.

Tighten the nuts back on the threads until it is snug against the box wall.

When you run your wire, do so through these connectors and tighten the connector down on the wire

to keep water and insects out.

• In the upper left hand corner, under the board, there is a backup battery. Find the red and black wires

with the connector on the end. [B]

Plug the backup battery into the board when you are done with your wiring, it is easier to fish the

wires out however before mounting the box.

• Mount the control box in a secure location near the gate opener control box.

• The intercom control box will have 4 wires coming into it from the speaker/mic box, 2 wires coming

in for power and 2 wires going out to the gate opener. (this is for minimum installation—additional

wires may be used in more advanced installations)

See the chart on the next pages for wire locations and power instructions.

[A] [B]

1 2 3 4 5 6 7 8 ... 16 17

No comments

Estate Swing User Manual Page 3