1W10300459AW10296137A-SPDRYER SAFETY ... 2INSTALLATION REQUIREMENTS ...
103-wire connection: Direct wireUse where local codes permit connecting cabinet-ground conductor to neutral wire.Direct wire cable must have 5 ft. (1.
114. Connect the other wires to outer terminal block screws. Tighten screws.5. Tighten strain relief screws.6. Insert tab of terminal block cover i
12Clamps:Use clamps to seal all joints. Exhaust vent must not be connected or secured with screws or other fastening devices that extend into inter
13Level DryerCheck the levelness of the dryer. Check levelness rst side to side, then front to back.If the dryer is not level, prop up the dryer usin
1411. When the dryer has been running for 5 minutes, open the dryer door and feel for heat. If you feel heat, cancel cycle and close the door.If you d
156. Be certain to keep cardboard spacer centered between doors. Reattach outer door panel to inner door panel so handle is on the side where hinges
16W10300459AW10296137A-SP© 2009 12/09All rights reserved Printed in U.S.A.
2DRYER SAFETYYou You can be killed or seriously injured if you don't immediately can be killed or seriously injured if you don'tfollow All
3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w
4Installation clearances:The location must be large enough to allow the dryer door to open fully. Dryer Dimensions ABDC433/8"(1102
5Install Leveling LegsWARNINGExcessive Weight HazardUse two or more people to move and install dryer.Failure to do so can result in back or other inju
6Electrical ConnectionPower Supply CordWARNINGFire HazardUse a new UL listed 30 amp power supply cord. Use a UL listed strain relief. Disconnect power
73. Install strain relief.Style 1: Power supply cord strain reliefRemove the screws from a 3/4" (19 mm) UL listed strain relief (UL marking on
83. Connect neutral ground wire (E) and the neutral wire (C) (white or center wire) of power supply cord under center, silver-colored terminal block
94. Tighten strain relief screws.5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw.6. You have
Comments to this Manuals